Equinox Systems MEGAPLEX Manual do Utilizador Página 71

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 238
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 70
AMIS Analog Networking
585-300-512 Issue 7
May 1999
AUDIX Administration
3-19Implementation
3
2. Check the rescheduling increments near the bottom of the form.
The incr1 through incr5 fields define how long the local system waits
before attempting to retransmit messages that could not be delivered on
the original attempt.
For AMIS Analog Networking, the system attempts to send the message
once at the specified delivery time (usually immediately). If it is not
successful, it uses the intervals specified in incr1 and incr2 for its second
and (if needed) third attempts. When the system has made three
unsuccessful attempts, the message is marked as undeliverable and the
sender is notified through a new voice mail message.
For Message Delivery, the system attempts to send the message once at
the specified delivery time (usually immediately). If it is not successful, it
uses the intervals specified in incr1, incr2, incr3, incr4, and incr5 for a total
of six attempts (if needed). When the system has made six unsuccessful
attempts, the message is marked as undeliverable and the sender is
notified through a new voice mail message.
3. If you changed any rescheduling increments, press or (F1).
4. Press to exit the form.
Task 7: Restart the AUDIX System
To activate feature changes you made during the implementation phase, you
should restart the system.
NOTE:
If this is a new AMIS analog networking or message delivery system, you
may want to perform Task 8
before
Task 7. A system restart at the end of
initial AMIS analog networking/message delivery implementation ensures
the network is brought up cleanly.
Select an appropriate time to bring the system out of service, then do the
following:
1. Type
st
on the path line to access the startup form. Press .
2. To restart the system, press or (F1).
3. After the system reinitializes, you have to log back in to do further
administration.
CHANGE RUN
Ctrl-z
RETURN
CHANGE RUN
Vista de página 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 237 238

Comentários a estes Manuais

Sem comentários