
AMIS Analog Networking
585-300-512 Issue 7
May 1999
DEFINITY AUDIX Administration
4-11Implementation
4
b. Start Time/End Time
Specify at least one start time and one end time to implement AMIS
analog networking and/or message delivery. Up to three cycles
(periods of time) may be specified. The sum of the cycles must be
less than 24 hours; a cycle may span midnight, but may not overlap
another cycle.
NOTE:
The AMIS analog networking and message delivery
transmission times specified on the Machine screen must be
equal to or a subset of the outcalling periods specified here.
Make a note of the outcalling cycle(s).
c. Interval
This field does
not
apply to AMIS analog networking or message
delivery; the intervals in this field apply only to the Outcalling
feature (if activated). You will use the System-Parameters Features
screen to administer the intervals for AMIS analog networking
and/or message delivery (done in Task 7).
d. Maximum Simultaneous Ports
Specify the maximum number of ports that may be used
simultaneously for outcalling, AMIS analog networking, and/or
message delivery during the specified cycle. You may need to
increase this number if you were previously using the Outcalling
feature and are now adding the AMIS Analog Networking and/or
Message Delivery features. See the "Voic e Port Need s" section in
Chapter 2, "Planning and Design"
,
for more information.
e. Initial Delay
This field does
not
apply to AMIS analog networking or message
delivery; it applies only to the Outcalling feature (if activated).
f. Maximum Number Digits
This field does
not
apply to AMIS analog networking or message
delivery; it applies only to the Outcalling feature (if activated).
3. Press (F3) to save your data and exit the screen.
4. You need to reboot the system or run an audit to activate these changes
(done in Task 8).
ENTER
Comentários a estes Manuais