Equinox Systems MEGAPORT Manual de Instruções descarregar pdf (Página 36)

30 Equinox MEGAPORT Hardware Reference Manual

FM Modular Splitter

FM modular splitters are used with modular adaptors and modular

cables. This splitter converts the 100-pin MEGAPORT 12FM board

connector to a set of 12 RJ-45 modular jacks. Figure 3-9 illustrates

devices connected to the MEGAPORT using the FM modular splitter.

● The FM modular splitter (Equinox part number 990173)

converts the signals on the 100-pin connector to 12 RJ-45

modular jacks. This modular splitter is used to connect

the MEGAPORT board to ports requiring full modem

control.

● 10-wire modular cable must be used to attach devices to the

splitter.

Figure 3-10. Modular cable signals

Modular Cables

RJ-11 modular cable is the flat cable used for wiring telephones

inside of buildings. The cable is terminated at each end with an RJ-

11 modular plug (connector) which is inserted into the modular jack

of an appropriate wiring module. Standard modular cables available

from Equinox or wiring distributors are reversing; that is the pins

are reversed on each end (so that pin 1 on one end is connected to

pin 6 on the opposite end, etc.). Figure 3-10 illustrates the signals

passed through modular cables when connected to a CS port using

the Equinox part number 210016 CS modular splitter.

Figure 3-9. FM Modular splitter

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Sem comentários

Equinox Systems MEGAPORT Manual de Instruções Página 36