Equinox Systems MEGAPORT Manual de Instruções descarregar pdf (Página 15)

Installing MEGAPORT Boards 9

Chapter 2

Installing MEGAPORT Boards

This chapter describes how to install MEGAPORT, MEGAPORT/2

and MEGAPORT/RS boards into a computer system. The following

topics are covered:

● The MEGAPORT Board

● EISA Installations

● Intermixing MEGAPLEX and MEGAPORT Boards

● Installing a Single MEGAPORT Board

● Installing Multiple MEGAPORT Boards

● PS/2 Type Hardware Configuration

● RS/6000 Hardware Configuration

● Installing the Round Cable

The MEGAPORT Board

Figure 2-1 is an illustration of the MEGAPORT boards. No hardware

configuration is required on the board. However, make careful note of

the J2 and J3 connector locations. J2 is the input connector and J3 is

the output connector. These connectors are used when more than one

MEGAPORT board is installed. Interconnections between boards are

not required when installing multiple MEGAPORT/2 or

MEGAPORT/RS boards.

Figure 2-1. MEGAPORT, MEGAPORT/2 and MEGAPORT/RS boards

MEGAPORT/2 and

MEGAPORT/RS

MEGAPORT

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Sem comentários

Equinox Systems MEGAPORT Manual de Instruções Página 15