Equinox Systems MEGAPORT Manual de Instruções descarregar pdf (Página 21)

Installing MEGAPORT Boards 15

PS/2-Type Hardware Configuration

MEGAPORT/2 only.

This section applies to the IBM PS/2, the NCR 3000 Series and other

similar Micro Channel Architecture computers. The process described

is essentially the same for each, although some terminology may vary.

After installing the MEGAPORT/2 board, the computer must be

configured. The first time the machine is turned on with the

MEGAPORT/2 installed, an error code of 165 appears on the screen

and 2 beeps are sounded after the RAM is counted. This error

message indicates that the configuration has been changed and the

machine must be reconfigured to recognize the MEGAPORT/2.

Micro Channel machines require an Adapter Description File (ADF)

to automatically configure each peripheral device (adapter) installed.

The system identifies the adaptor by requesting a Programmable

Option Select (POS) ID from adapters installed in the computer. The

POS ID for the MEGAPORT/2 is 6384. The corresponding ADF file

(@6384.ADF) for the MEGAPORT/2 containing the configuration

information for the board is provided on the MEGAPORT/2 Option

Diskette. This file must be copied to a backup of the Reference Diskette

supplied with the computer. The steps for coping the file to the

Reference Diskette backup disk are presented below:

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Sem comentários

Equinox Systems MEGAPORT Manual de Instruções Página 21